Kenwood TM-741A - Manual (Page 19)

&
Ts 8.8:8.8s Шв88:8.8.1 !Ts 88:8.8.
*88 'Ш“!!1Ч“Ч!Ш SI *88 |ИРдаччч<Ш SI *88 в»'Ш!Ш|Ш! SI
—+
REV
CTCSS CO
DTSS ^
SO.
— +
REV
CTCSS CO
DTSS ^
■4ЕШ^
SO
CTCSS CO m ON
Чжг
_ A.LOC
C AP
J TOT
A.B.C
MUTE
^188 Displays the operating frequency to the ®
nearest kHz digit, or the tone frequency. f-------1—
• The indicator flashes when scanning.
■ On when receive detection output is fixed
__
in the band. © ni^
On whenever the F key has been OFF
depressed. © SLEEP
Shows the last memory channel number
that was selected. The ★ indicator is on ©
LOCK
when the Memory channel will be skipped
during Memory channel scan.
A,LOCK
On in paging mode.
-On when the squelch opens. @
apo
This level meter indicates the relative
receiver signal strength or the relative
@ TOT
transmitter power output.
On during transmit.
@ д.В.С.
Indicates the relative output power
setting for transmit. No indicator
@> MUTE
indicates full power.
s
* B 8
P B
L M
1200MHz band only; On when the Automatic
-Lock Tuning function is active.
28/50 MHz band only; On when Attenuator is
on.
On when the TIME ON/OFF function has
been activated.
On when the SLEEP TIMER function has
been activated.
On when the Lock function has been
activated.
On when the All Lock function has been
activated.
On when the Automatic Power Off
function has been activated.
On when the Time-Out Timer function
has been activated.
On when the Automatic Band Change
function has been activated.
On when the volume of the RX band is
reduced.
19