Kenwood TM-741A - Manual (Page 67)

7-3-3. DTMF Memory
With the optional DTMF unit DTU-2, DTMF telephone
numbers can be stored into memory.
■Storing the DTMF codes
1. Press and hold the F key and the CALL key, then
turn the POWER switch ON to select the DTMF code
entry mode.
C£) (HD
POWER (( '¡¡)
p --------------------
■Recalling stored DTMF code in receive mode
1. Press and hold the F key and the CALL key, then
turn the POWER switch ON to select the DTMF codes
entry mode.
2. Press the MR key on the microphone.
3. Press the numeric key (0~9) that corresponds to the
desired DTMF memory channel.
4. The code are displayed as shown.
p
- l г з
2. Enter the DTMF code on the DTMF code key (up to a
maximum of 15 digits).
3. After the DTMF code is entered, press the PF key.
If you enter the wrong number, press the VFO key on
the microphone to start again.
4. Press the channel (0 ~ 9) where you want to store the
DTMF code. When the DTMF code is stored to that
channel, the DTMF code entry mode reappears on the
display.
5. To complete the DTMF code entry mode, press the
PTT switch, UP/DWN key, or any front panel key.
■Making a DTMF Call
1. Press the BAND SEL key to equalize TX band and
RX band.
2. Press the PF key while holding the PTT switch down
then press the numeric key that corresponds to the
desired DTMF memory channel.
The DTMF code is output .The display shows the code.
NOTES
Transmission continues until the whole code string is
recalled even if the PTT switch is released.
67