Kenwood TM-741A - Manual (Page 40)

This function allows you to specify which memory
channels you wish to skip during memory channel scan.
1. Press the MR key to select the memory channel mode.
2. Select the memory channel that you wish to skip by
turning the Tuning control or pressing the
microphone UP/DWN keys.
3. Press the F key for longer than 1 second. The F
indicator will begin to flash. Within 10 seconds of
pressing the F key press the MR key. A ★ indicator
will appear to the left of the memory channel number.
This indicates the memory channel will be skipped
during the memory channel scan mode.
4-5-10. Memory Channel Lockout
($)
1 sec
’ --- ^
¡ O H S
i ^ u n n n ^ 5 l u n
iW i.uuu H H J . i i u
* I H -----------------------------
Repeat steps 2 and 3 to lock out any other channels
you wish to skip.
To cancel the lockout, select the desired memory
channel as described in steps 1, 2 and 3 above. A ★
indicator should appear to the left of the memory
channel number. Press the F key for longer than 1
second and then press the MR key. The ★ indicator
should turn off.
Demonstration mode
The microprocessor has been programmed to provide
a short demonstration of the capabilities of the
transceiver. To activate this demonstration press and
hold the CALL key while you turn on the power switch.
After a 10 seconds delay the transceiver will enter the
demonstration mode.
You can cancel this function by holding the VFO key
down while you turn on the power.
Press and hold
(^CALL^
POWER (C --- ))
foJoi/ HobbiJ
NOTE
When you cancel the demonstration mode you will
clear all VFO information, and reset the VFO’s to
the factory defaults. You won’t erase your memory
channel data, just the VFO data, so you might wish
to store your VFO data into memory before entering
the demonstration mode so this information can be
easely recalled.
40