Kenwood TM-741A - Manual (Page 31)

1. Press the VFO key to select the VFO mode.
2. Select the desired receiver frequency, tone
information etc. (For example 443.600MHz)
3. Press the F key momentarily. The F indicator will
light on the display, and a memory channel number
will appear.
4-4-5. Memory Entry 5.
/
lOHS
, . , u n n n ° ^ D c n n
I H 1 . U U U H H J . b u u
______ ®S3..........
4. Select any memory channel using the Tuning control
or microphone UP/DWN keys.
(For example: CHS)
l O H S
, „ u n n n
I H n . U U U ' ^ ' ^ J . U U U
___ ® s____
•Normal channel
Press the MR key within 10 seconds of selecting the
memory channel number. The F indicator and
memory channel number will turn off. This signals
that the data has been properly stored in memory.
7.
•Odd Split memory channel (continue from
step 4)
Press the MR key for longer than 1 second within 10
seconds of selecting the memory channel number.
The — + indicator indicates the TX frequency
selection mode.
_ ^
¡OHS
l u U n n n ^ D C n n
H n . u u u H H j . b u u
___ ® s____
6. TX frequency entry
Select the desired transmit frequency.
(For example 442.600MHz)
l O H S
I ^ u n n n ' ^ p c n n
l ^ i . u u u H ' i C . b u u
.... . ® s____
Press the MR key.
To confirm the contents of the odd split memory
channel:
Press the MR key. The programmed receiver
frequency should appear in the display along with
both a “ —” and “ + ” offset direction indicator. This
signals you that this channel has an odd split entered.
31