2-2. frequency selection, Mode selection, Frequency selection – Kenwood TM-741A User Manual
Page 22: Dtss code selection, Tons, Step size [khz
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
7. Turn off the transceiver’s Power switch before you
turn off the power supply, or in a vehicle, before you
stop the engine.
4-2-2. Frequency Selection
You can change the dial frequency while in the VFO
mode. The frequency can also be stored in memory, or in
the call channel.
1. Press the VFO key to select the VFO mode.
2. Rotate the tuning control, or press the microphone
UP/DWN switches to select the desired frequency.
Mode selection
You can select the VFO mode. Memory channel mode, or
Call channel mode using the following keys.
1. Press the VFO key to select the VFO mode.
2. Press the F key momentarily. The F indicator should
light on the display.
3. Press the REV/STEP key within 10 seconds of
pressing the F key. The current frequency step size
will be displayed.
4. Rotate the Tuning control or press the microphone
UP/DWN keys until the desired tuning step size
appears in the display.
C S )
G E )
tons
5
,1,. n o n n
step Size [kHz]
5^10^15?i20?=i12.5=i25i*
5. To complete the programming of the step size you can
press any front panel key or simply wait 10 seconds
and the microprocessor will automatically return to
the normal frequency display.
4-2-3. Frequency Step Selection
T
0
select the desired tuning or scan step size use the
following procedure:
22