Brother MFC4550 PLUS - Manual (Page 95)

2. Wait for two seconds.
3. Press 1.
4. Press 6.
5. Press 6.
6. Press (left arrow) or ► (right arrow)
to find the SET mode.
\ [T]. FAX
------\
2 . P R I N T E R
1 . F A X
6 . T E L O P T I O N S
6 . D I S T I N C T I V E
C
D I S T I N C T I V E i O F F
S E L E C T e ^ & S E T
:)
D I S T I N C T I V E i S E T
7. Press Set.
8. Prfiss Stop.
NOTE: The display should say
D/R SET MODE.
Also, the answer mode lights will
flash. You must now wait for
someone to call the distinctive
ringing fax number.
Troubleshooting Tip---------------------------------
6 . D I S T I N C T I V E
D / R S E T M O D E
O N L I N E
If your MFC display shows
D/R SET MODE
and you are not in the process of setting up
a distinctive ringing number, press the
Stop
key to exit this function. The Settings will
remain unchanged.
9. When the phone rings, listen carefully to
check that the ringing pattern is the one
you want to register. If it is, wait until the
display says
PICK UP TO SET. Then pick
up the MFC handset.
10. Press Start to set. Check that the display
says REGISTERED.
(If the other number was called, press
Stop to cancel.)
11. Press Start again to receive the incoming
fax, or if the call is a voice call, talk into
the handset.
P I C K U P T O S E T
C
S T A R T T O S E T
S T O P T O C A N C E L
:)
R E G I S T E R E D
T E L E P H O N E / F A X
O N L I N E
8 3