Brother MFC4550 PLUS - Manual (Page 90)

i\uvyi_i VII 1'w/1 / / \i N1^ 11 iLi\ v^nLLj vu.mnvimuA mLlíнt^lmA^swt:l{L^GDlíVlCE {TAD j
Flowchart of External TAD Reception
Incoming Call
The call is picked up
by the external TAD.
(Maximum four rings.)
Fax reception is
automatically
activated by
fax tones.
Auto
dialed
fax call
The external TAD
outgoing message
begins.
Voice cail
Manual
dialed
fax call
I
The fax message The caiier leaves a
is received on voice message on the
paper. external TAD.
The caller must
press your Remote
Activation Code
to activate the
MFC.
The fax meeeage is
received on paper.
The caiier
can aiso
send a fax message.
TAD H ookup
There is only one way you can hook up a Telephone Answering Device (TAD) on the
fax phone line. The TAD must be plugged into the back of the MFC in the jack labeled
EXT. Yntir MFC cannot work p-roperly if you plug the TAD into a wall jack. Follow
these steps:
1. Plug the telephone line cord from the wall jack into the back of the MFC in the jack
labeled LINE.
2. Plug the telephone line cord from your TAD into the back of the MFC in the jack
labeled EXT. (Double check that the telephone line cord comes from the jack in the
TAD for telephone line and not for telephone set.)
3. Put your MFC in TAD mode by turning both the Fax and F/T lights on.
4. Set your TAD to four ringG or less. (The MFC’s Ring Delay setting does not apply).
5. Turn the TAD’s Answer mode to ON.
6. Record the OGM (outgoing message) on your TAD as explained on the next page.
7 8