Brother MFC4550 PLUS - Manual (Page 115)

Rem ote Control Com m ands
i
You can control your MFC with the following remote control commands.
Remote control command Detail Operation
9 5 Changing Fax Forwarding
/Paging setting
1 OFF If you hear one long beep, the change is accepted. If you hear
three short beeps, you can not change it because the conditions
(ex. registering fas forwarding or paging number) have not boon
completed. You can register your fax forwarding number by
using 4. FAX FWD No. (see page 104). Once you have registered
the number, the machine automatically will turn to “FAX
FWD;ON” mode. To receive a Memory Status List, enter 961 (see
page 104). Check the List to make sure the Fax Forwarding
number you registered is correct. Then enter the confirmation
command 955. Now the MFC will start Fax Forwarding.
2 Fax Forwarding
3 Paging
4 FAXFWDNo.
5 FWD No. Confirm
6 Fax Storage ON You can set FAX STORAGE ON or OFF.
7 Fax Storage OFF
96 Retrieve FAX
1 Memory Status List You must call fi’om a remote fax machine to receive the Memory
Status List or stored fax message(s). (See page 104.)
2 00 Retrieve all FAXES
2 “MSG No.” 00
Retrieve by MSG
number
3 Erase FAX in the
memory
If you hear one long beep, you can erase fax message(s) from the
memory.
97 Check the receiving status You can check whether your MFC has received any fax message(s).
If yes, you will hear one long beep. If no, you will hear three short
beeps.
1 FAX
98 Change Answer Mode If you hear one long beep, you can change the Answer Mode. If
you hear three short beeps, you can not change it.
1 TAD
2 F/T
3 Fax
90 Exit The MFC is reset. After a long beep, you can hang up.
1 0 3