Brother MFC4550 PLUS - Manual (Page 181)

Paper Handling Difficulties
Difficulty Suggestions
The MFC does not load
paper.
The LCD shows CHECK
PAPER or PRINTER
JAM. • Check to see if the CHECK PAPER or PRINTER JAM
message appears on the LCD. If so, the multi-purpose sheet
feeder may be out of paper or not properly installed. If it is
empty, load a new stack of paper into the feeder.
• If there is paper in the multi-purpose sheet feeder, make sure
it is straight. If the paper is curled, you should straighten it.
Sometimes it is helpful to remove the paper, turn the stack
over and put it back into the paper tray.
• Reduce the amount of paper in the multi-purpose sheet
feeder, then try again.
The MFC does not load
paper from the manual
feed stop. Reinsert the paper firmly, one sheet at a time.
How can I load
envelopes? You can load envelopes from either the multi-purpose sheet
feeder or the manual feed slot. Your application software must
be set up to print the envelope size you are using. This is usually
done in the Page Setup or Document Setup menu of your
software. Refer to your apphcation manual.
What paper can I use? You can use plain paper, envelopes, transparencies, labels, and
organizer paper. For information on loading paper. See
“Acceptable Paper” in Chapter 9.
How can I clear paper
jams?
See “Paper Jams” on pages 146--148.
169