Brother MFC4550 PLUS - Manual (Page 145)

12. REPLACING TONER CARTRIDGE AND DRUM UNIT
Toner Empty Indicator
When the toner cartridge is running low, the display will show CHANGE TONER and
the Toner Empty LED on the control panel will flash on and off to indicate the toner
is low.
Display Toner Empty LED
The Toner Empty LED will light and the display will show CHANGE TONER and
TONER EMPTY alternately to indicate that the toner is empty. Once this indication
appears, your MFC will not resume printing until you have installed a new toner
cartridge.
Replacing the Toner Cartridge * •
The MFC can print approximately 2,200 pages with one toner cartridge. When the
toner cartridge is running low, the display shows CHANGE TONER. The MFC is
supplied with a starter toner cartridge that must be replaced after 1,000 pages.
NOTE: • Actual page count will vary depending on your average document type,
(i.e., standard letter, detailed graphics, etc.)
• It is recommended that you always keep a new toner cartridge ready for
use for when you see the toner low warning.
• Discard the used toner cartridge according to local regulations. If you are
not sure of them, consult with Brother Customer Service. Be sure to seal
the toner cartridge tightly so toner powder does not spill out of the
cartriiige. When disrarding used toner cartridges, keep them separate
from domestic garbage.
• It is recommended that you clean the MFC when you replace the toner
cartridge.
133