Brother MFC4550 PLUS - Manual (Page 88)

l^CV^CI VIINV:? TMACO UIntK UALLC5 REMOTE ACmM'lUS
6. Press (left arrow) or ► (right arrow)
to choose ON or OFi'.
Example: ON.
7 . Press Set.
8. Enter new remote code to activate.
(Factory setting is *51.) Then press Set.
9. Enter new remote code to deactivate.
(Factory setting is #51.)
10. Press Set.
R E M O T E A C T . : 0 N
A C T . C O D E ; * 5 1
D E A C T . C 0 D E : t 5 1 '
5 : R E M O T E C O D E
11. Press Stop to exit.
C) CONNECTING A TELEPHONE ANSWERING DEVICE (TAD)
How to Use an External TAD with the MFC ____________________________________
When you have a Telephone Answering Device on the fax phone line, the TAD will
answer all the incoming calls. Your Brother MFC will listen in on the line for fax CNG
tones. If it hears them, it will take over the call and receive the fax message. If it does
not hear fax tones, it will let the TAD continue playing the outgoing message so the
caller can leave a voice message.
The TAD must answer within four rings. The MFC cannot hear the CNG calling
tones until the TAD answers the call. When the Ring Delay is set for four rings, only
8-10 seconds of CNG calling tones are left for the “handshake.” So you must strictly
follow the instructions for recording the OGM.
You must erase the incoming messages frequently on your TAD. When the TAD’s
memory is full it will not answer any incoming calls (fax or voice).
Set the MFC’s answer mode to TAD mode (Fax and F/T lights lit). (See page
61.)
7«