Kenmore 385.16231 User Manual
Page 44
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
' Tension is too loose
(1) Needle thread (Top thread)
@ Bobbin thread (Bottom thread)
(3) To tighten tension
(i)
Right side (Top side) of fabric
(5) Wrong side (Bottom side) of fabric
The needle thread shows through on the wrong side
of the fabric, and the stitch feels bumpy. Turn the dlai to a
higher tension setting number to tighten the needle thread
tension.
Adjust the Needle Thread Tension for a Zigzag
Stitch
For an ideal zigzag stitch, the bobbin thread does not show
on the right side (Top side) of the fabric, and the needle
thread shows slightly on the wrong side (Bottom side) of the
fabric.
See the illustrations for the correct appearance
To match this appearance, adjust the needle tension.
»Correct tension
0
Right side (Top side) of fabric
0 Wrong side (Bottom side) of fabric
Minimize the amount of needle thread visible on the
wrong side (Bottom side) of the fabric without causing
excessive puckering, or causing the bobbin thread to
show on the right side (Top side) of the fabric.
Results vary with fabric, thread and sewing conditions.
' Tension is too tight
0 Right side (Top side) of fabric
(2) Wrong side (Bottom side) of fabric
The corner of each zigzag pulls together on the right side
of the fabric
• Tension is too loose
0
Right side (Top side) of fabric
(2) Wrong side (Bottom side) of fabric
The corner of each zigzag pulls together on the wrong
side of the fabric.