beautypg.com

Changing needle, To remove and attach the foot holder, Changing presser foot – Kenmore 385.16231 User Manual

Page 24

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

background image

Changing Needle

© Needie clamp screw

(g) Needie clamp

[©Turn off the power switch.

Raise the needie to its highest position by turning the
handwheel counterclockwise, toward you, and towering

the presser foot. Loosen the needle damp screw© by
turning it counterclockwise. Remove the needie from the

needie clamp©.

[U insert a new needle into the needle Giamp©wtth the

fiat side to the rear When inserting the needie into the

needle damp©, push it up as far as it goes. Tighten

the needle ciamp screw © firmly by turning it ciockwise.

IUT

o

see if the needle is good, place the flat side of the

needle onto something fiat {needie plate, giass, etc.)..

The gap between the needie and the flat surface should

be consistent. Never use a bent or blunt needle,

A damaged needle can cause permanent snags or runs

in knits, fine silks and silk-like fabrics.

To Remove and Attach the Foot Holder

©Thumb screw
@ Foot holder
© Presser bar
« To remove

Remove the thumb screw©by turning it counterciockwise

with a screwdriver,

• To attach

Match the hole in the foot holder ©with the threaded
hole in the presser bar ©, Fit the thumb screw©into

the hole. Tighten the screw©by turning it clockwise with

a screwdriver.

Changing Presser Foot

© Snap-on button (red button)
© Groove
©Pin
• To remove

Raise the needle to its highest position by turning the
handwheel counterclockwise. Raise the presser foot, and
press the red button ©on the back of the foot holder.

• To attach

Place the selected presser foot, so that the pin© on the

foot lies just under the groove@on the foot holder. Lower
the presser bar to lock the foot into piace.

12