Kenmore 385.16231 User Manual
Page 38
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
« Removing the hook cover plate
0 Hook cover plate release button
d) Hook cover píate
Slide the hook cover plate release button®to the right,
and remove the cover plate (|).
»Inserting the bobbin
® End of thread
(2) Notch
(3) Notch
0 Threading diagram
[T] Place a bobbin in the bobbin holder \vlth the thread
running off counterclockwise.
[
2
] Guide the thread into notch (g)or) the front side of
the bobbin holder. Draw the thread to the ieft, sliding it
between the tension spring blades,
I Continue to draw the thread lightly until the thread slips
into notch (3). Puli out about 6" {15.0 cm) of thread
[
4
] Attach the hook cover plate, Check the threading by
referring to the diagram®shown on the hook cover plate
26