KEYENCE LJ-V7000 Series User Manual
Page 72

72
LJ-V7000_COM_RM_E
• Master regist
Type:10h~1Fh (10h:Program NO.0, 11h:Program NO.1,
, 1F:Program NO.15)
Category:02h, Item:10h
Target1:00h (headA/wide), 01h (headB), Target2~4:00h
byte
Setting Data
0
ON/OFF: 0:Correction disabled, 1:Correction
enabled
1
Reserved (fixed as 0)
2
Reserved (fixed as 0)
3
Reserved (fixed as 0)
4
Area start position1: any value in measurement
range
(0.01μm unit Sined 32-bit integer
example: 5mm=500000)
5
6
7
8
Area end position1: any value in measurement
range
(0.01μm unit Sined 32-bit integer
example: 5mm=500000)
9
10
11
12
Area start position2: any value in measurement
range
(0.01μm unit Sined 32-bit integer
example: 5mm=500000)
13
14
15
16
Area end position2: any value in measurement
range
(0.01μm unit Sined 32-bit integer
example: 5mm=500000)
17
18
19
20
Post-correction height 0~999.99mm: 0~99999
21
22
23
24
Correction span: 1~131071
*The correction span is the value devided by
65536. (Condition:0 example: if 98304 is set, (98304÷65536=1.5) correction span is 1.5. 25 Type:10h~1Fh (10h:Program NO.0, 11h:Program NO.1, , 1F:Program NO.15) Category:03h, Item:01h byte Setting Data 0 valid/invalid: 0:Master invalid, 1:Master valid 1 Reserved (fixed as 0) 2 Reserved (fixed as 0) 3 Reserved (fixed as 0) 4 Profile data amount (*1): 50,75,100,150,200,300,400,600, 800,1200,1600 5 6 Reserved (fixed as 0) 7 Reserved (fixed as 0) 8 Xcoordinate data start position (*2) (0.01μm unit Sined 32-bit integer) 9 10 X direction pitch (*2) (0.01μm unit, Sined 32-bit integer) 13 Profile (0.01μm unit Sined 32-bit integer) *3 17 ~ ~ ~ 3212 Profile (0.01μm unit Sined 32-bit integer) 3213 3215 *1 Profile data amount depend on the setting. Refer to 10.2 "Profile data amount calculation method" or receive *2 It depends on the type of sensor head and settings. Please confirm by receiving "MasterProfile" *3 This example is in case of 800 points (It depends on Profile data amount.)
26
27
Target1:00h (headA/wide), 01h (headB), Target2~4:00h
11
12
14
15
16
18
19
~
~
3214
"MasterProfile" and confirm it.