KEYENCE EX-V Series - Manual (Page 96)

Chapter 4 Use of Data Processing Functions
4
86
4.7 Initialization
All specified functions can be reset to the initial settings.
Note: When the functions are initialized, the adjustment data for the output
characteristics will also be erased. Be sure to adjust the output characteristics
again after the initialization. (
➮ Refer to page 9.)
1. Hold down the key and turn ON the power of the sensor.
• The sensor displays "U- ■■ ■■ ".
• Now the sensor is reset to the initial settings.
➮ For the details of the initial settings, refer to "4.1 Table of Data Processing Functions" on
page 46.
2. Press the key again.
The sensor enters the measurement state.
3. Turn OFF the power once and turn it ON again.
SET
CALL
HIGH TIM
GO
LOW
FUNC UTILITY MODE CALIB
* "00" displayed above is an example.
When values other than "00" are displayed,
the initialization is successful.