KEYENCE EX-V Series User Manual
Page 36
Chapter 2 Quick Guide to Basic Mode Operation
2
26
3. Press the
key.
•
The sensor automatically enters the HIGH limit value setting mode.
•
The setting value is displayed in red and the HIGH indicator illuminates.
Note: Setting the panel-lock function to ON allows the terminals to switch the
setting number for the tolerance limits. For details of the panel-lock function, see
"Panel-lock function [ ]" (
➮ page 43).
4. Press the
or
key to display the desired value.
•
Pressing the
key changes the flashing digit to the right.
•
Pressing the
key changes the value.
•
All digits flash when the fifth digit and sign can be changed.
5. Press the
key.
•
The HIGH limit setting value is saved. The sensor automatically enters the
LOW limit value setting mode.
•
Set the LOW limit value using the same procedure as in steps 3 and 4.
Note 1: The output is disabled during the tolerance limit value setting. When the
output is already on, however, the output is retained.
Note 2: Pressing the
key does not save the changes if [HIGH setting value -
Hysteresis] is smaller than [LOW setting value + Hysteresis]. In this case, “Err1” is
displayed. Press the
key again to cancel the error, and then specify the correct
values.
HIGH
TIM
GO
LOW
HIGH
TIM
GO
LOW
HIGH
TIM
GO
LOW
No setting
(5th digit)
(1st to 4th digits)
W