KEYENCE EX-V Series User Manual
Page 30
Chapter 2 Quick Guide to Basic Mode Operation
2
20
Reference: Four kinds of tolerance limit values ("0" to "3") can be saved in the
memory. The registered setting numbers can be switched using external signals
(
➮ page 4).
3) Press the
key.
• The sensor automatically enters the HIGH limit value setting mode.
• The setting value is displayed in red and the HIGH indicator illuminates.
4) Press the
or
key to display the desired value.
• Pressing the
key changes the flashing digit to the right.
• Pressing the
key changes the value.
• All digits flash when the fifth digit and sign can be changed.
5) Press the
key.
The HIGH limit setting value is saved. The sensor automatically enters the
LOW limit value setting mode.
6) Press the
key again.
7. Activate the machine to check whether the comparator output correctly works
according to the tolerance limit setting values.
•
The GO comparator output indicator on the controller illuminates when the
measured value is within the tolerance range. The HIGH indicator illuminates
when the measured value is higher than the upper limit value. The LOW
indicator illuminates when the measured value is lower than the lower limit
value.
•
To perform fine adjustment of the tolerance limit values, repeat steps 5) and
6) described above.
HIGH
TIM
GO
LOW
HIGH
TIM
GO
LOW
No setting
(1st to 4th digits)
(5th digit)
HIGH
TIM
GO
LOW