KEYENCE EX-V Series - Manual (Page 41)

Chapter 3 Use of Common Functions
3
31
3.2 Function Setting Flow
This section explains how to set functions "E" through " j" using the key.
3.2.1 Selecting the function using the key
Select the function to be set from functions "E" through " j" and then enter the
desired function number or numeric value.
1. Press the key for at least 2 seconds.
• The sensor enters the common function selection mode.
• The function parameter of the flashing function code can be set.
2. Press the key to select the function to be set.
Pressing the key changes the flashing digit to the right.
3. Press the or key to enter the function number setting state.
4. Set the function parameter.
➮ For details of each function, see pages 33 to 43.
5. Press the key.
The sensor saves the setting and returns to the measurement state.
6. To set two or more functions, repeat steps 1 through 5 described above.
SET
CALL
HIGH TIM
GO
LOW
FUNC UTILITY MODE CALIB
SET
CALL