Pilz PSENvip RL D P - Manual (Page 67)

5.2 Install transmitter and receiver
5 Installation
Pilz GmbH & Co. KG, Felix-Wankel-Straße 2, 73760 Ostfildern, Germany
Telephone: +49 711 3409-0, Telefax: +49 711 3409-133, E-Mail: [email protected]
5-2
5.2 Install transmitter and receiver 5200 Install transmitter and receiver 5- Montage_Sender_Empfaenger_Zusatz  Fastening kits for the transmitter and receiver are available as acces-
sories (for order no. see Chapter 11, "Technical Details").
Montage_Sender_Empfaenger  The fastening kit consists of an adapter plate and adjustment plate
with a slot nut. The bracket on the upper die must have a correspond-
ing groove in which to insert the slot nut (see Fig. 5-1).
Fig. 5-1: Dimensions of adapter plate with groove, dimensions in
mm
 Both the transmitter and receiver are installed in the same way. Only
the dimensions of the adjustment plates for the transmitter and re-
ceiver are different.
To install the system, proceed as follows:
 Fasten the adjustment plate as shown in the diagram below. Ensure
that the flat washers, spring washers and nuts are attached in the
right order.
14+0,3
7+0,3
15
+0,2
8,3
+0,2
1
17+0,5
(4x) ø15
(4x) ø8.4
(32)
5
(71.5)
115
35
35 27
A-A B
B