Pilz PSENvip RL D P - Manual (Page 4)

Contents
Pilz GmbH & Co. KG, Felix-Wankel-Straße 2, 73760 Ostfildern, Germany
Telephone: +49 711 3409-0, Telefax: +49 711 3409-133, E-Mail: [email protected]
2
4.4.3.2 Outputs 4-15
4.4.3.3 LED 4-17
4.4.3.4 Key display and function 4-17
4.4.4 Communication with the safety system 4-21
4.5 Protected field modes 4-25
4.5.1 Standard protected field mode 4-25
4.5.2 Box bending protected field mode 4-25
4.5.3 Back gauge protected field mode 4-26
4.5.4 Box bending with back gauge protected
field mode 4-27
4.6 Operating modes during commissioning 4-29
4.6.1 Press brake setup mode 4-29
4.6.2 Adjustment during initial commissioning 4-29
4.6.3 Adjustment during tool change 4-29
4.7 System cycle 4-31
4.7.1 System cycle for standard press stroke 4-31
4.7.2 System procedure in box bending press
stroke 4-33
4.7.3 System cycle for back gauge press stroke 4-35
4.7.4 System cycle in for box bending with back
gauge press stroke 4-36
4.7.5 System cycle for overrun measurement 4-36
Chapter 5 Installation
5.1
General requirements 5-1
5.2 Install transmitter and receiver 5-2
5.3 Dimensions 5-4
5.3.1 Transmitter 5-4
5.3.2 Receiver 5-4
5.3.3 Fastening kit for the transmitter 5-5
5.3.4 Fastening kit for the receiver 5-6
5.3.5 Bracket for transmitter and receiver 5-6
Chapter 6 Wiring
6.1
Notes on wiring 6-1
6.2 Connections 6-4
6.2.1 Receiver 6-4
6.2.2 Transmitter 6-6
6.2.3 Supply voltage 6-6
6.2.4 Connection between transmitter and re-
ceiver 6-6
6.2.5 Connection diagram 6-6
Chapter 7 Commissioning
7.1
Commissioning guidelines 7-1
7.2 Initial commissioning 7-2