Casio CLASSPAD 330 3.04 - Manual (Page 377)

20060301
6-5 Drawing a Cobweb Diagram
You can use the procedure described here to input a sequence and draw a cobweb diagram.
Example: To graph , a
1
= 0.5
S\ ClassPad Operation
(1) Start up the Sequence Editor.
• If you have another application running, tap / and then .
• If you have the Sequence application running, tap and then [Sequence Editor].
(2) Tap the [Recursive] tab.
(3) Specify the recursion type by tapping [Type] and then [ a
n+ 1
Type a
1
].
(4) Input the recursion expression.
• Tap the input box to the right of a
n+ 1
:, and then use the procedures under “6-2
Inputting an Expression in the Sequence Application” to input the following.
[ n , a
n
] [ a
n
] :
(5) Input the initial value.
(6) Tap and then [View Window].
• This displays a dialog box for configuring View Window settings.
(7) Configure View Window settings as shown below.
xmin = –2 xmax = 3 xscale = 1 xdot: (Specify auto setting.)
ymin = –1 ymax = 1 yscale = 1 ydot: (Specify auto setting.)
(8) After everything is the way you want, tap [OK].
(9) Tap .
(10) Press for each
step of the web.
Tip
• On the cobweb graph window, you can draw the cobweb diagram again by selecting Trace on the
Analysis menu.
6-5-1
Drawing a Cobweb Diagram
a
n +1
=
a
n
2
– 1
2