Casio CLASSPAD 330 3.04 - Manual (Page 119)

20060301
Calculation Error
An error message dialog box, like the one shown below, appears when there is a problem
with the syntax of an input expression or value, when the number of decimal places of a
calculation result in the Standard mode (page 2-2-6) exceeds a specified range, etc. Tap [OK]
to close the dialog box and return to the calculation.
Tip
• The text of the error message dialog box depends on the type of error that occurred. For details,
see the “Error Message Table” on page α -10-1.
• If you perform a calculation that is mathematically undefined (such as division by zero), the
message “Undefined” appears in place of the calculation result, without display of an error
message.
2-2-4
Basic Calculations
Assigning a Value to a Variable
Besides using the variable assignment key (6, page 1-7-6), you can also use the syntax
shown below in the Main application and eActivity application to assign a value to a variable.
Syntax: Variable: = value
Example: Assign 123 to variable x
S\ ClassPad Operation
(1) Perform the key operation below in the Main application work area.
7+@AB
(2) U
Important!
“:=” can be used only in Main and eActivity. It can NOT be used in a program. In the Program
application, you must use 6 to store a value to a variable.