Repair a dropped or damaged computer, Repair a dropped or damaged, Computer – Dell PRECISION 530 User Manual
Page 168

168
Solving Problems
w
w
w
.d
e
ll
.co
m
|
s
u
p
p
o
rt
.d
e
ll.c
o
m
15
Reconnect the computer and devices to their electrical outlets, and
turn them on.
16
Run the System Board Devices test group in the
.
Did any of the diagnostics tests fail?
Yes.
for technical assistance.
No. The problem is resolved.
Repair a Dropped or Damaged Computer
CAUTION:
Before you perform this procedure, see "
NOTICE:
Before disconnecting a device from the computer, wait 10 to 20
seconds after disconnecting the computer from its electrical outlet. Before
removing a component from the system board, verify that the standby power
light on the system board has turned off. To locate this light, see "
" or the interior service label.
as you perform the following steps:
1
Turn off the computer and devices, disconnect them from their
electrical outlets, and wait 10 to 20 seconds.
2
Lay the computer on its right side.
3
4
Check all the expansion-card connections in the computer, and reseat
any loose expansion cards.
5
Ensure that all cables are properly connected and that all components
are properly seated in their connectors and sockets.
6
7
Stand the computer upright.
8
Reconnect the computer and devices to their electrical outlets, and
turn them on.
9
Run the System Board Devices test group in the
.
Did any of the diagnostics tests fail?
Yes.
for technical assistance.