Dell PRECISION 530 User Manual
Page 170
170
Solving Problems
w
w
w
.d
e
ll
.co
m
|
s
u
p
p
o
rt
.d
e
ll.c
o
m
NOTE:
If you installed up to 4 GB of memory but not all of it is available for
use by the
Addressing Memory with 4-GB Configurations
Basic Checks:
•
Check the
to see if the specific problem is identified.
•
If an insufficient memory message appears, save and close any open
files and exit any open application programs not in use. Consider
installing additional system memory.
•
Restart the computer.
•
Run the System Memory test group in the
.
•
If you have the optional memory riser boards installed, reseat the riser
boards.
•
Reseat the memory modules in system board or riser board sockets.
•
If you are not using the optional memory riser boards, verify that all
system board memory sockets contain a
or
•
Memory modules must be installed in matched pairs. Ensure that the
modules installed in system board or memory riser board socket pairs
are identical. To identify system board socket pairs, see "
." To identify memory riser board socket pairs,
see "
."
If the problem still exists after you complete the basic checks, fill out the
as you perform the following steps.
CAUTION:
Before you perform this procedure, see "
NOTICE:
Before disconnecting a device from the computer, wait 10 to 20
seconds after disconnecting the computer from its electrical outlet. Before
removing a component from the system board, verify that the standby power
light on the system board has turned off. To locate this light, see "
" or the interior service label.
1
Enter
and ensure that the value for System Memory
matches the actual amount of memory installed in the computer.
Does the memory total correctly match the actual amount of memory
installed in the computer?