Dell PRECISION 530 - Manual (Page 81)

Removing and Installing Parts 81
Installing a Memory Module
1 Press the securing clips at each end of the socket outward until they
snap open (see the following figure).
2 Align the slots on the bottom of the module with the ridges inside the
socket.
NOTICE: To avoid damage to the memory module, press the module straight
down into the socket with equal force applied at each end of the module.
3 Press the module straight down into the socket until the securing clips
snap into place at the ends of the module.
I n s t a l l i n g a M e m o r y M o d u l e
Removing Memory Riser Boards
NOTICE: Before disconnecting a device from the computer, wait 10 to 20
seconds after disconnecting the computer from its electrical outlet. Before
removing a component from the system board, verify that the standby power
light on the system board has turned off. To locate this light, see "
System Board
Components " or the interior service label.
1 Remove the microprocessor airflow shroud .
2 Remove the memory riser board retention bracket (see the following
figure).
slots (2)
securing clips (2)
memory socket