Dell PRECISION 530 - Manual (Page 117)

Removing and Installing Parts 117
Microprocessor Airflow Shroud
• Removing the microprocessor airflow shroud
• Installing the microprocessor airflow shroud
Removing the Microprocessor Airflow Shroud
CAUTION: Before you perform this procedure, see " Safety First—
For You and Your Computer ."
NOTICE: Before disconnecting a device from the computer, wait 10 to 20
seconds after disconnecting the computer from its electrical outlet. Before
removing a component from the system board, verify that the standby power
light on the system board has turned off. To locate this light, see "
System Board
Components " or the interior service label.
1 Turn off the computer and devices, disconnect them from their
electrical outlets, and wait 10 to 20 seconds.
2 Lay the computer on its right side.
3 Open the computer cover .
4 Remove the airflow shroud:
• Press down and back on the indentations at the top corners of the
shroud.
The top anchor tabs will disengage from the chassis anchor slots.
See the following figure.
• Lift the airflow shroud out of the chassis.