Canon Pixma MP530 - Manual (Page 85)

Chapter 4 83 Faxing
4
Press [OK].
The receive mode will be displayed on the bottom left of the LCD.
(A) Receive mode
„ Canceling Receiving
Press [Stop/Reset] and follow any instructions on the LCD.
„ Memory Receiving
If ink has run out while receiving a fax, if ink level is low, if the setting is incorrect, or if the
setting is other than , the fax is automatically stored in memory and
is displayed. When the ink tank is replaced or the paper size setting
is corrected, the stored fax is printed automatically.
FAX ONLY MODE: See “If You Want to Receive Only Faxes Automatically with Your
Machine, or You Have a Dedicated Telephone Line for Fax Use
Only:” on page 80
.
MANUAL MODE: See “If You Receive Mainly Voice Calls and Sometimes Faxes, or
You Want to Receive Faxes Manually:” on page 80 .
ANS.MACHINE MODE: See “If You Want to Receive Voice Messages on Your Answering
Machine and Receive Faxes Automatically:” on page 81 .
FAX/TEL AUTO SW: See “If You Want to Receive Faxes Automatically as well as Voice
Calls:” on page 81 .
DRPD: See “If You Have Subscribed to a Distinctive Ring Pattern
Detection (DRPD) Service with Your Telephone Company (US and
Canada only):” on page 82
.
NETWORK SWITCH: See “If You Want Your Machine to Automatically Switch between
Fax and Voice Calls by the Call Ring Patterns (Network Switch)
(This setting is not available in some countries and regions.):” on
page 82
.
Note
For details on the receive modes, see “Receive Modes” on page 80 .
Note
z The machine can store up to approximately 150 pages* of faxes in memory.
z If the memory becomes full, the machine cannot receive the remaining faxes. Print or
delete the documents stored in memory (see
“Printing or Deleting a Document in Memory”
on page 77 ), and then contact the sender and have him/her resend them.
* When using ITU-T No.1 chart (Standard mode)
02/15/2006 WED 06:11
FAX/TEL
STANDARD
(A)