Canon Pixma MP530 - Manual (Page 118)

116 Chapter 9 Troubleshooting
INCOMPATIBLE CAMERA
DISCONNECT CAMERA CABLE Disconnect the camera cable, and reconnect it.
Depending on the model or brand of your device, you may have to select a
print mode compliant with PictBridge before connecting the camera.
You may also have to turn on the camera or select Play mode manually
after connecting the camera to the machine. Perform necessary
operations according to the instruction manual supplied with your
camera.
If the error is still unresolved, there is a possibility that you are using a
digital camera or digital video camcorder that is not supported by this
machine. Use a digital camera or digital video camcorder compatible with
this machine.
INK LOW The ink level becomes low during printing.
Press [OK] to continue printing or press [Stop/Reset] to cancel the current
print job.
INNER COVER IS OPEN If the Inner Cover is open when starting normal printing, close it before
pressing [OK] on the machine.
LOAD PAPER Reload the paper correctly and press [OK].
Note
Pressing [Stop/Reset] also enables you to resolve the error, when sending
faxes before printing out received data. After you press [Stop/Reset] to
resolve the error, ensure to press [FAX] in order to print out data remained
in memory.
MEMORY IS FULL The machine’s memory is full because you tried to copy too many pages
at once or a very detailed document.
Divide the document and copy each part separately.
The machine’s memory is full because it has received too many
documents, or a very long or detailed document.
Contact the sender and have him/her divide and resend them.
PAPER JAMMED If paper has jammed in the machine, clear the jam, reload the paper in the
machine correctly and then press [OK].
PRESS [BLACK] [Color] is pressed.
Press [Black].
PRESS [COLOR] [Black] is pressed.
Press [Color].
SCANNER ERROR Contact the Canon Customer Care Center.
WASTE INK NEAR FULL Ink used for cleaning is absorbed in a waste ink absorber placed in the
machine.
Press the [OK] to cancel the error so that you can continue printing. Once
the waste ink absorber becomes completely full, printing cannot be done
until the waste ink absorber is replaced.
Canon recommends to contact a Canon Customer Care Center as soon as
possible.
You will need to replace a particular part of the machine.
Message Action