Canon Pixma MP530 - Manual (Page 22)

20 Chapter 1 Before Printing
z Using the Platen Glass
1
Open the Document Cover.
2
Load your document on the Platen Glass.
z Place your document face down on the Platen Glass.
z Align the upper left corner of your document with the alignment mark on the upper left
corner of the Platen Glass.
3
Gently close the Document Cover.
Note
z Make sure any glue, ink, correction fluid, or the like is completely dry before loading the
document.
z Remove all staples, paper clips, and the likes before loading the document.
Note
z The machine cannot scan the area within about 0.08" / 2 mm from the rear edge, and
within about 0.08" / 2 mm from the left edge of the Platen Glass.
z You can also scan in originals that are up to 0.39" / 10 mm thick, such as books. Set them
on the Platen Glass in the same way as documents.