ClearOne Converge Pro Serial - Manual (Page 46)

273
PANGM – PA Noise Gate Mode
This command sets the Noise Gate mode to be either manual or automatic. In manual mode the gate threshold
will be used to activate. In auto mode the noise floor will be used to activate.
Command Form : DEVICE PANGM [Value]
Argument Type Size Values Units
Channel Channel 1 See Groups and Channels -
Group Group 1 23 (J) -
Value Unsigned Short 2 0 = Automatic
1 = Manual
(Null to query in text)
-
PANGT – PA Noise Gate Threshold
This command sets the Noise Gate Threshold that will be used when in the manual mode. This represents the
level at which the noise gate will activate.
Command Form : DEVICE PANGT [Value]
Argument Type Size Values Units
Channel Channel 1 See Groups and Channels -
Group Group 1 23 (J) -
Value Signed Float 2 -100.00 to 0.00
(Null to query in text)
dB
PAPOL – Polarity Switch
This command changes audio signal polarity on a power amplifier channel.
Command Form : DEVICE PAPOL [Value]
Argument Type Size Values Units
Channel Channel 1 See Groups and Channels -
Group Group 1 23 (J) -
Value Unsigned Short 2 0 = Normal
1 = Reverse
2 = Toggle
(Null to query in text)
-
PARST – PA Reset
This command resets the power supplies on an individual power amplifier circuits. There is no query associated
with this command.
Command Form : DEVICE PARST [Value]
Argument Type Size Values Units
Channel Channel 1 See Groups and Channels -
Group Group 1 23 (J) -
Reserved Zero 2 Zero -
PASME – PA Sound Mask Enable
This command enables the sound mask signal on a PA Channel
Command Form : DEVICE PASME [Value]
Argument Type Size Values Units
Channel Channel 1 See Groups and Channels -
Group Group 1 23 (J) -
Value Unsigned Short 2 0 = Voice Mode
1 = Wideband Mode
(Null to query in text)
-