ClearOne Converge Pro Serial - Manual (Page 25)

252
FE – Feedback Elimination Enable
This command enables or disables feedback elimination on the power amplifier channel.
Command Form : DEVICE FE [Value]
Argument Type Size Values Units
Channel Channel 1 See GroupAndChannels -
Group Group 1 23 (J) -
Value Unsigned Short 2 0 = On
1 = Off
2 = Toggle
(Null to query in text)
-
FEB – Feedback Elimination Bandwidth
This command sets the filter bandwidth of the notch filter. Options are a Q = 5 or Q = 10
Command Form : DEVICE FEB [Value]
Argument Type Size Values Units
Channel Channel 1 See GroupAndChannels -
Group Group 1 23 (J) -
Value Unsigned Short 2 0 = 5
1 = 10
Default 0 (5)
(Null to query in text)
-
FEDR – Feedback Elimination Dynamic Node Reset
This command will reset only the dynamic filters on the feedback eliminator. There is no query associated with this
command.
Command Form : DEVICE FEDR
Argument Type Size Values Units
Channel Channel 1 See GroupAndChannels -
Group Group 1 23 (J) -
Reserved Zero 2 Value:0-16
(Null to query in text)
Nodes
FEF – Feedback Elimination Fixed Filter
This command sets the number of fixed filter to use in the feedback eliminator. The fixed filters number will be
used during the initialization phase when gain is increased until feedback occurs. A fixed filter will be set at the
feedback point during the initialization.
Command Form : DEVICE FEF [VALUE]
Argument Type Size Values Units
Channel Channel 1 See GroupAndChannels -
Group Group 1 23 (J) -
Reserved Unsigned Short 2 Zero -
FEG – Feedback Elimination Auto Gain Max
This command sets the target gain for auto setup in feedback cancellation.
Command Form : DEVICE FEG [Value]
Argument Type Size Values Units
Channel Channel 1 See GroupAndChannels -
Group Group 1 23 (J) -
Reserved Unsigned Short 2 0 - 8
(Null to query in text)
dB