Metrohm tiBase 1.1 - Manual (Page 35)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
2 General program functions
tiBase 1.1
￭￭￭￭￭￭￭￭ 27
Variable
name
(PC-Control)
Variable
name
( tiBase 1.1)
Description Command
.RMS .MR.MRS Standard deviation for mean
dosing rate for the whole range
in mL/min STAT, DOS
.RM .MR.MRT Mean dosing rate for the whole
range in mL/min STAT, DOS
.MTM .MTE Temperature measurement with
sensor; 1 = on, 0 = off) DET, MET, SET, KFT, STAT,
MEAS (without T/Flow),
CAL MEAS, STDADD, DOS
.MMP .NMP Number of measuring points
(number of measuring points in
the measuring point list) DET, MET, SET, KFT, KFC,
STAT, MEAS, CAL MEAS,
DOS
.RDC# .RE{x}.DRC Correlation coefficient for mean
dosing rate in window x (1…9) STAT
.RDS# .RE{x}.DRS Standard deviation for mean
dosing rate in window x (1…9)
in mL/min STAT
.RD# .RE{x}.[DRT] Mean dosing rate in window x
(1…9) in mL/min STAT
.MCM .RES Result calculated from the stand-
ard addition curve (concentration
of the selected unit) STDADD
.MSL .SLO Electrode slope of the sensor
used for the command (in % for
pH sensor or mV for ISE sensor,
number) or electrode slope cal-
culated from the calibration (for
CAL LOOP) DET pH, DET U, MET pH,
MET U, SET pH, SET U,
STAT, MEAS pH, MEAS U,
MEAS T, MEAS Conc, CAL
LOOP, DOS, STDADD
.MSM .SME Start measured value (measured
value after processing the start
conditions) in the unit of the
measured value DET, MET, SET, KFT, KFC,
STAT
.MST .STE Start temperature (temperature
after processing of the start con-
ditions) in °C DET, MET, SET, KFT, KFC,
STAT
.MTS .STY Type of stop with which the
command was stopped: 1 = nor-
mal; 0 = manual or after error DET, MET, SET, KFT, STAT,
MEAS, CAL MEAS,
STDADD, DOS
.MSA .SVA Start volume absolute (volume
that was added according to the
start condition "start volume") in
mL DET, MET, SET, KFT, STAT