Metrohm tiBase 1.1 - Manual (Page 299)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
4 Database
tiBase 1.1
￭￭￭￭￭￭￭￭ 291
Command type
Selection of the command type for which the curve properties are to be
defined. The curve properties defined for each command type are saved
per curve window and per client.
Selection DET | MET | SET | KFT | KFC | BRC | STAT |
MEAS | DOS
Default value DET
Note
When the dialog window is opened, those Command type will be
selected as standard which applies for the curve shown in the curve
window.
Autoscaling
on | off (Default value: on)
If this option is switched on then all axes in the curve window will be
scaled automatically. In this case the fields Start value and End value
cannot be edited.
Available columns
Shows all fields that can be displayed as columns in the measuring point
list.
Displayed columns
Shows all fields that will be shown as columns in the measuring point list.
Adds the selected column to the measuring point list.
Removes the selected column from the measuring point list.
Modifies the sequence of displayed columns by moving the selected col-
umn up and down.