Metrohm tiBase 1.1 - Manual (Page 254)

4.5 Determination overview
￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
246 ￭￭￭￭￭￭￭￭
tiBase 1.1
Input range RS01 - RS25
Default value none
Statistics
on | off (Default value: on)
If this check box is activated, the mean value and the absolute and relative
standard deviation are calculated for the result. This field is only active
when the statistics is enabled in the method of the imported determina-
tion (i.e. the statistics can only then be disabled and enabled again, if it
has already been enabled in the method).
Description
Freely selectable description of the result.
Entry 1000 characters
Default value empty
4.5.2.6.4.7.2 Monitoring
Tab: Database ▶ Determinations ▶ Reprocessing ▶ Modifications ▶ Calcula-
tions ▶ [New]/[Properties] ▶ Result 'Result name' - RS## ▶ Monitoring
Result monitoring
If this check box is activated, then the limit values for the result of the cal-
culation formula are being monitored.
Lower limit
Lower limit for the result. This parameter is only editable when the result
monitoring is enabled.
Entry 10 digits
Default value 0
Upper limit
Upper limit for the result. This parameter is only editable when the result
monitoring is enabled.
Entry 10 digits
Default value 99999.99999
Message
Only editable when the check box Monitoring result is activated.
Selection Display message | Record message
Display message
If this option is selected, the message "The limit value for the result 're-
sult name' has been exceeded." appears. At the same time the mes-
sage is documented, i.e. it is saved in the determination.