13 determinations - displaying history, 14 determinations - make current, 15 determinations - show calibration curve – Metrohm tiBase 1.1 User Manual
Page 261: Displaying determination history
■■■■■■■■■■■■■■■■■■■■■■
4 Database
tiBase 1.1
■■■■■■■■
253
4.5.2.13
Determinations - Displaying history
Menu item: Database
▶ Determinations ▶ Show history
Switch history view on/off
With the menu item Determinations
▶ Display history... or the symbol
only the currently focused determination in the Determination table as
well as all the previous versions of this determination will be shown.
If the History view with the menu item Determinations
▶ Display his-
tory... or the symbol
is disabled again, then the original selection of
determinations in the Determination table will appear again.
4.5.2.14
Determinations - Make current
Menu item: Database
▶ Determinations ▶ Make current
Make old version current
With the menu item Determinations
▶ Make current... or the symbol
the determination version selected in the determination table will again
be made the current determination version. This creates a new determina-
tion whose version number is increased by +1 compared with the last ver-
sion to have been saved.
4.5.2.15
Determinations - Show calibration curve
Dialog window: Database
▶ Determinations ▶ Show calibration curve… ▶ Calibra-
tion curve
With the Determinations, Show calibration curve… menu item or
the symbol the calibration or standard addition curve is shown for the
determination selected in the Calibration curve dialog window.
Calibration curve for CAL LOOP pH
In the Calibration curve dialog window a tab marked with the com-
mand name showing the calibration curve and calibration data will be dis-
played for each CAL LOOP pH command . The command type is shown
above the calibration curve. The curve display shows the measured values
and the curve calculated from these measured values. Listed below are the
individual measured values and the results for Slope, E(0) and Variance.
Calibration curve for CAL LOOP Conc
In the Calibration curve dialog window a tab marked with the com-
mand name showing the calibration curve and calibration data will be dis-
played for each CAL LOOP Conc command . above the calibration curve.
The curve display shows the measured values and the curve calculated
from these measured values. Listed below are the individual measured val-
ues and the results for Slope, E(0), c(blank) and Variance. Calibration
curve for CAL LOOP Conc