Metrohm tiBase 1.1 - Manual (Page 290)

4.8 Curves subwindow
￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
282 ￭￭￭￭￭￭￭￭
tiBase 1.1
For BRC commands
Selection
Time [s] | Measured value | Amount [µg] |
Charge [mAs] | Drift [µg/min] | dV/dt [µ/min] |
Ugen | Igen [mA] | Calculated 1...3 | External
1...3
Default value Time [s]
For MEAS commands
Selection
Time [s] | Measured value | dMW/dt | Temper-
ature [°C] | Calculated 1...3 | External 1...3
Default value Time [s]
Label
Freely definable axis label for the x axis. With auto the designation from
the field Size will be used.
Selection 50 characters | auto
Default value auto
Scaling
Start value
Initial value for scaling the x axis.
Only editable when autoscaling is disabled.
Input range
-1.00E+12 - +1.00E+12
Default value 0
End value
End value for scaling the x axis.
Only editable when autoscaling is disabled.
Input range
-1.00E+12 - +1.00E+12
Default value 1000
4.8.3.3 Curve properties - y1 axis
Dialog window: Database ▶ Curves ▶ Properties curves # ▶ y1 axis
Parameters for the graphical display of the curves on the y1 axis (left-hand
y axis).
Command type
Selection of the command type for which the curve properties are to be
defined. The curve properties defined for each command type are saved
per curve window and per client.