Rockwell Automation AADvance Controller Safety Manual - Manual (Page 101)

 
Document: 553630
ICSTT-RM446K-EN-P Issue: 10
_C
4-45
Functional Stress 5Hz to 9Hz
Continuous 1.7mm amplitude
Occasional 3.5mm amplitude
Withstand 10Hz to 150Hz
Acceleration 0.1g in 3 axes
Endurance 10Hz to 150Hz
Acceleration 0.5g in 3 axes
Shock 15g peak, 11ms duration, ½ sine
Altitude
Operating 0 to 2000m (0 to 6,600 ft.)
Storage and Transport 0 to 3000m (0 to 10,000 ft.)
This equipment must not be transported in
unpressurized aircraft flown above 10,000 ft.
Electromagnetic Interference Tested to the following standards: EN 61326-
1:2006, Class A; EN 61326-3-1:2008, EN 54-4:
1997, A1; EN 61131-2:2007; EN 62061:2005.
Hazardous Location Capability Suitable for Class I Div 2 and Zone 2.
IMPORTANT
 This equipment is not certified for use in a
Zone 1 location
 This equipment is not certified for use in a
Zone 0 hazardous environment.
Note:
Casing: Standard AADvance modules also have a plastic casing and are rated IP20:
Protected against solid objects over 12mm (1/2in.) for example "fingers".There is no
specific protection against liquids.
Electromagnetic Immunity and Emissions
The AADvance system has been designed and tested to withstand normal
levels of conducted and radiated electromagnetic interference and electrostatic
discharge. Electrical noise conditions may vary greatly, depending on the
equipment installation, wiring, other installed equipment, and its proximity to
the AADvance equipment.
A detailed analysis of the installation electrical and magnetic conditions is rare.
It is therefore necessary to ensure that the system as a whole complies with
the client's requirements or appropriate standards EN6100-6-2:2005 and
EN6100-6-4:2007; within Europe, the CE mark requirements form a legal
minimum.