Rockwell Automation SP200 AC Drive, 1 2 Channel Analog, Preset Speed - Manual (Page 14)

4-2 Installing and Operating the SP200 AC Drive
4.1 Wire AC Power to the Drive and Motor
Use the following procedure to wire power to the drive and motor.
Step 1. Remove the finger guards by inserting a screwdriver in the slot at the front of
each guard and pushing gently.
Step 2. For 115 VAC input power only, remove the protective label from the 115
VAC terminal.
Step 3. Connect the incoming AC line to the appropriate input power terminals as
shown in figure 4.1.
Step 4. Connect a ground wire to the drive’s input grounding screw (labeled PE ).
This grounding conductor must run unbroken from the drive to earth ground.
Step 5. Connect the output power terminals from the drive to the motor as shown in
figure 4.2.
Step 6. Replace the finger guards by locating the tabs in the slots adjacent to the
power terminal block and pressing each guard into place.
Figure 4.2 – Three-Phase AC Output Power Connections
Figure 4.1 – AC Input Power Connections