Rockwell Automation AutoMax Enhanced Ladder Language Reference Manual - Manual (Page 68)

4Ć8
4.2.2 Output Parameters for the Greater Than Or Equal To Instruction
This table lists the outputs for the GE instruction. To use these outputs, connect them to
a contact, coil, or Boolean input of another instruction.
Parameter Description
ENO Use this output as the input to another instruction for easily
chaining multiple instructions. This output follows the state of
EN unless an error occurs.
Q This output is set true when all of the following conditions occur:
D the instruction is enabled
D In1 is greater than or equal to In2
D if In3 is used, In2 is greater than or equal to In3
Otherwise, Q is false.