Rockwell Automation 2711P PanelView Plus Terminal User Manual - Manual (Page 95)

Publication 2711P-UM001J-EN-P - November 2009 95
Configuration Mode Chapter 4
Run the Loaded Application on Startup
Follow these steps to run the loaded application on startup.
1. Select Terminal Settings>Startup Options>FactoryTalk View ME
Station Startup.
2. Press the On Startup button to select Run Current Application.
If an application is not loaded, the options are disabled.
3. Press the Replace RSLinx Communications button to specify
what configuration settings to use when running the application.
•
Select No to use the RSLinx configuration of the terminal.
•
Select Yes to use the configuration of the application. The
terminal configuration is replaced with the application
settings. Any changes to device addresses or driver properties
in RSLinx communication will be lost.
4. Press the Delete Log Files to specify what action to take with the
log files on startup.
•
Select Yes to delete all log files (data, alarm history, alarm
status) generated by the terminal before running application.
The files are deleted from the system default location.
•
Select No to retain all log files.
5. Press OK twice to return to Terminal Settings.