Replace the battery – Rockwell Automation 2711P PanelView Plus Terminal User Manual User Manual
Page 153
Publication 2711P-UM001J-EN-P - November 2009
153
Install and Replace Components Chapter 6
Replace the Battery
The terminals have a lithium battery that is used by the real-time clock
and static RAM. It is not used for application backup or retention.
•
For the 700 to 1500 terminals, the lithium battery is intended to
be replaced during the life of the product.
•
For the 400 and 600 terminals, the lithium battery is permanently
connected and should be removed only by trained professionals
at the end of product life.
For information on battery removal for 400 and 600 terminals,
see
.
The 700 to 1500 terminals contain a hermetically sealed lithium
battery which may need to be replaced during the life of the
product.
At the end of its life, the battery contained in this product
should be collected separately from any unsorted municipal
waste.
The collection and recycling of batteries helps protect the
environment and contributes to the conservation of natural
resources as valuable materials are recovered.
ATTENTION
To avoid voiding your product warranty, use only the Rockwell
Automation Allen-Bradley approved battery. Use of another
battery may present a risk of fire or explosion.
SHOCK HAZARD
Failure to follow proper safety precautions could result in
severe electrical shock or damage to the computer.
WARNING
There is a danger of explosion if the lithium battery is
incorrectly replaced. Replace the battery only with the
indicated type. Do not replace the battery unless the area is
known to be nonhazardous.
For Safety information on the handling of lithium batteries,
including handling and disposal of leaking batteries, see
Guidelines for Handling Lithium Batteries, public
.
Replace the battery only with the indicated catalog number.
Do not dispose of battery in a fire or incinerator. Dispose of
used batteries in accordance with local regulations.