Rockwell Automation 2711P PanelView Plus Terminal User Manual - Manual (Page 31)

31 Publication 2711P-UM001J-EN-P - November 2009 31
Chapter
2
Installation
Chapter Objectives This chapter provides pre-installation information and procedures on
how to install the terminals.
•
Hazardous locations
•
Environment and enclosure
•
Outdoor installation for 1250 high-bright display module
•
Required tools
•
Clearances
•
Panel cutout dimensions
•
Mount the 400 or 600 terminal in a panel
•
Mount the 700 to 1500 terminals in a panel
•
Product dimensions
Hazardous Locations When marked, this equipment is suitable for use in these locations:
•
Class I, Division 2, Groups A, B, C, D
•
Class I, Zone 2, Group IIC
•
Class II, Division 2, Groups F, G
•
Class III
•
ordinary, nonhazardous locations
The following statement applies to use in hazardous locations.
WARNING
Explosion Hazard
•
Do not disconnect equipment unless power has been removed and
area is known to be nonhazardous.
•
Do not disconnect connections to this equipment unless power has
been removed and the area is known to be nonhazardous.
•
Substitution of components may impair suitability for
Class 1, Division 2.
•
Peripheral equipment must be suitable for the location it is used in.
•
The battery or realtime clock module in this product must only be
changed in an area known to be nonhazardous.
•
All wiring must be in accordance with Class I, Division 2, Class II,
Division 2, or Class III, Division 2 wiring methods of Articles 501, 502
or 503, as appropriate, of the National Electrical Code and/or in
accordance with Section 18-1J2 of the Canadian Electrical Code, and
in accordance with the authority having jurisdiction.