Rockwell Automation 2711P PanelView Plus Terminal User Manual - Manual (Page 174)

174 Publication 2711P-UM001J-EN-P - November 2009
Chapter 7 Terminal Connections
Ethernet Connections The base-configured unit of the 700 to 1500 terminals and the network
based unit of the 400 and 600 terminals have an Ethernet port that
supports:
•
EtherNet/IP communication.
•
third-party Ethernet communication.
•
network connections.
•
application uploads/downloads.
•
printing.
Ethernet Connector
The base-configured unit of the terminals has an RJ45,
10/100 Base-T connector for EtherNet/IP or Ethernet TCP/IP network
communication.
The table shows the connector pinouts.
Ethernet Connector Pinout
Use point-to-point, 10/100 Base-T cables with cross over pin-outs,
such as 2711P-CBL-EX04, when connecting the Ethernet port on the
terminal directly to a logic controller’s Ethernet port or a computer
10/100 Base-T port.
Ethernet Port
Insert plastic tie wrap in
hole and use as strain relief
for all attached cables.
RS-232 serial port RS-232 serial port
Pin Pin Pin Name
Looking into RJ45
Connector
1 TD+
2 TD-
3 RD+
4 NC
5 NC
6 RD-
7 NC
8 NC
Shield Connection No direct connection
(AC coupled to chassis GND)
1 8