Recover from a lost password – Rockwell Automation 2080-LC20-20QBBR Micro820 20-point Programmable Controllers User Manual User Manual
Page 69

Rockwell Automation Publication 2080-UM005A-EN-E - December 2013
61
Controller Security Chapter 7
Recover from a Lost
Password
If the controller is secured with a password and the password has been lost, then it
is impossible to access the controller using the Connected Components
Workbench software.
To recover, the controller must be set to Program Mode using the keyswitch for
Micro830 and Micro850 controllers, the 2080-LCD for Micro810 controllers, or
the 2080-REMLCD for the Micro820. Then, ControlFlash can be used to
update the controller firmware, which also clears the controller memory.
ATTENTION:
The project in the controller will be lost but a new project
can be downloaded.
This manual is related to the following products:
- 2080-LC20-20AWBR Micro820 20-point Programmable Controllers User Manual 2080-LC20-20QWBR Micro820 20-point Programmable Controllers User Manual 2080-LC20-20AWB Micro820 20-point Programmable Controllers User Manual 2080-LC20-20QBB Micro820 20-point Programmable Controllers User Manual 2080-LC20-20QWB Micro820 20-point Programmable Controllers User Manual