C - quickstarts, Flash upgrade your micro800 firmware, Appendix c – Rockwell Automation 2080-LC20-20QBBR Micro820 20-point Programmable Controllers User Manual User Manual
Page 129: Quickstarts, Appendix

Rockwell Automation Publication 2080-UM005A-EN-E - December 2013
121
Appendix
C
Quickstarts
This chapter covers some common tasks and quickstart instructions that are
aimed to make you familiar with the in Connected Component Workbench. The
following quickstarts are included:
Flash Upgrade Your
Micro800 Firmware
This quick start will show you how to flash update the firmware in a Micro800
controller using ControlFLASH. ControlFLASH is installed or updated with
the latest Micro800 firmware when Connected Components Workbench
software is installed on your computer.
On Micro820 controllers, users can use flash upgrade their controllers through
the Ethernet port, in addition to the USB port of the 2080-REMLCD.
1. Through USB
: Verify successful RSLinx Classic communications with
your Micro800 controller by USB using RSWho. Micro810 12-pt.
controller uses the 12PtM810_xxxxx driver, the Micro820 uses the
2080_REMLCD_xxxx driver, and the Micro830/Micro850 uses the
AB_VBP-x driver.
Topic
Page
Flash Upgrade Your Micro800 Firmware
ATTENTION:
All Ethernet settings are reverted to factory default after
a ControlFlash firmware upgrade. For users who need to use the same
static IP address as previously set, for example, use the Memory
Module to store project settings prior to a flash upgrade so that you
can have the option to restore your original Ethernet settings.
- 2080-LC20-20AWBR Micro820 20-point Programmable Controllers User Manual 2080-LC20-20QWBR Micro820 20-point Programmable Controllers User Manual 2080-LC20-20AWB Micro820 20-point Programmable Controllers User Manual 2080-LC20-20QBB Micro820 20-point Programmable Controllers User Manual 2080-LC20-20QWB Micro820 20-point Programmable Controllers User Manual