Set controller password – Rockwell Automation 2080-LC20-20QBBR Micro820 20-point Programmable Controllers User Manual User Manual
Page 137

Rockwell Automation Publication 2080-UM005A-EN-E - December 2013
129
Quickstarts Appendix C
Set Controller Password
In the following instructions, the Connected Components Workbench software
is connected to the Micro800 controller.
1.
On the Connected Components Workbench software, open the project
for the target controller.
2.
Click Connect to connect to the target controller.
On the Device Details toolbar, roll over the Secure button. The tooltip
message “Set, Change, or Clear Micro800 Controller Password
Protection” is displayed.
3.
Click Secure button. Select Set Password.
IMPORTANT
After creating or changing the controller password, you need to power
down the controller in order for the password to be saved.
This manual is related to the following products:
- 2080-LC20-20AWBR Micro820 20-point Programmable Controllers User Manual 2080-LC20-20QWBR Micro820 20-point Programmable Controllers User Manual 2080-LC20-20AWB Micro820 20-point Programmable Controllers User Manual 2080-LC20-20QBB Micro820 20-point Programmable Controllers User Manual 2080-LC20-20QWB Micro820 20-point Programmable Controllers User Manual