Configure controller password – Rockwell Automation 2080-LC20-20QBBR Micro820 20-point Programmable Controllers User Manual User Manual
Page 136
128
Rockwell Automation Publication 2080-UM005A-EN-E - December 2013
Appendix C
Quickstarts
9.
Click Finish to complete.
Configure Controller
Password
Set, change, and clear the password on a target controller through the Connected
Components Workbench software.
IMPORTANT
The following instructions are supported on Connected Components
Workbench revision 2 and Micro800 controllers with firmware revision 2.
For more information about the controller password feature on Micro800
controllers, see
This manual is related to the following products:
- 2080-LC20-20AWBR Micro820 20-point Programmable Controllers User Manual 2080-LC20-20QWBR Micro820 20-point Programmable Controllers User Manual 2080-LC20-20AWB Micro820 20-point Programmable Controllers User Manual 2080-LC20-20QBB Micro820 20-point Programmable Controllers User Manual 2080-LC20-20QWB Micro820 20-point Programmable Controllers User Manual