Error codes – Rockwell Automation 2080-LC20-20QBBR Micro820 20-point Programmable Controllers User Manual User Manual
Page 121

Troubleshooting Appendix B
Rockwell Automation Publication 2080-UM005A-EN-E - December 2013
113
Error codes
This section lists possible error codes for your controller, as well as recommended
actions for recovery.
If an error persists after performing the recommended action, contact your local
Rockwell Automation technical support representative. For contact information,
go to
Indicator
Behavior
Probable Error
Probable Cause
Recommended Action
All indicators off
No input power or
power supply error
No line power
Verify proper line voltage and connections to the controller.
Power supply
overloaded
This problem can occur intermittently if power supply is overloaded when
output loading and temperature varies.
Power and FAULT
indicators on solid
Hardware faulted
Processor hardware
error
Cycle power. Contact your local Allen-Bradley representative if the error
persists.
Loose wiring
Verify connections to the controller.
Power on with
solid indicator and
FAULT indicator
flashing
Application fault
Hardware/software
major fault detected
For error codes and status information, refer to the Connected Components
Workbench online Help
Power on with
solid indicator and
FAULT indicator
flashing
Operating system fault
Firmware upgrade
unsuccessful
See
Flash Upgrade Your Micro800 Firmware on page 121
.
- 2080-LC20-20AWBR Micro820 20-point Programmable Controllers User Manual 2080-LC20-20QWBR Micro820 20-point Programmable Controllers User Manual 2080-LC20-20AWB Micro820 20-point Programmable Controllers User Manual 2080-LC20-20QBB Micro820 20-point Programmable Controllers User Manual 2080-LC20-20QWB Micro820 20-point Programmable Controllers User Manual