Rockwell Automation 1775-S4B,D17756.5.3 User Manual SCANNER/MSG HND - Manual (Page 63)

Editing a Procedure
Chapter 7
7Ć11
text on the line. If the 1775-S4B scanner cannot find the text that you
specify, the following message displays:
If you do not enter the change command correctly (such as not using the
same character for both delimiters), the 1775-S4B scanner displays the
following message:
Example using the change text characters command:
Suppose you want to change the word LINE to INDEX in the first line of
the procedure @EXAMPLE. If the first line of the procedure
@EXAMPLE contains the following text:
P ’LINE 1’
Simply enter C/LINE/INDEX/ after the asterisk:
P ‘LINE l’
* C/LINE/INDEX/ [ENTER]
The 1775-S4B scanner returns:
P ‘INDEX l’
*
As a second example, suppose you were editing a line which contains:
P ‘THIS IS A TEST’
If you want to change this line to read:
P ‘THIS WAS A TEST’
You could enter the following at the asterisk:
*C/IS/WAS/[ENTER]
The 1775-S4B scanner returns:
P ‘THWAS IS A TEST’
You must enter text that is unique in the line.
To correct our mistake enter: